Innovation of Tin Oxide Ceramic Manufacturing Process Based on WSN and Remote Visualization Technology

A wireless sensor network (WSN) collects information from small sensors, processes the information effectively through a built-in computing system, forms a dynamic network topology in a self-organizing method, and sends it to the base station through wireless communication. At the same time, the scale of data generated by high-performance scientific computing has rapidly increased from GB and TB to EB. The traditional scientific vision postprocessing model that initially saved the data and then performed the vision processing became a very time-consuming and troublesome process due to the limitation of disk I/O efficiency, which seriously affected the development of technology, and the accuracy was relatively low. The development of high-performance computer parallel processing technology has promoted parallel visualization, and the expansion of Internet bandwidth has accelerated remote visualization. SnO₂, or tin oxide, is a kind of N-type semiconductor material with a rutile structure. The crystal structure is stable, the corrosion resistance is good, the melting point is high, the resistance after doping is low, and the sinterability is good. Materials that are sensitive to optics, electrodes, and gases have a wide range of uses. This paper proposes a new data fusion algorithm based on BP neural network and studies the key technologies for the design and implementation of a web-based multiuser remote interactive vision system. In this paper, the effects of ZnO, MnO₂, Nb₂O₅, CuO, and Li₂CO₃ doping on the conductivity and bulk density of SnO₂ semiconductor ceramics were studied by means of ceramic preparation method, using intelligent resistance meter, bulk density tester, X-ray diffractometer, and scanning electron microscope, thus promoting the innovation of tin oxide ceramic preparation process.