Verification of morphological and physical properties for the development of a lung substitute phantom using...

This paper proposes a new concept of phantom development, along with the utilization of new materials that can reproduce lung morphology and density. A lung substitute phantom using microspheres was fabricated; then, its dosimetric utility in radiotherapy was investigated, during which the density was adjusted to closely resemble the morphology of the actual human lung. Microspheres were used to reproduce alveoli, which are the main components of the lung. By changing the ratio of urethane, which is commonly used in soft tissue phantoms, to microspheres, we reproduced the density change of the lungs due to respiration. Here, we fabricated two slab-like lung substitutes to emulate commercially used phantoms. Although there is room for improvement in terms of practicality, the substitutes were easy to fabricate. Microscopic observation of the cut surface of the phantoms showed that the morphology of the phantoms mimicked the alveoli more faithfully than commercial phantoms. Furthermore, to compensate for the energy-independent mass attenuation and mass collision inhibition ability required by the tissue substitute phantom, we examined the physical properties of the phantom and confirmed that there was negligible energy dependence.