Related Experiment Video
Updated: Sep 6, 2025

A Vibrotactile Feedback Device for Seated Balance Assessment and Training
Published on: January 20, 2019
Muscle recruitment patterns and saddle pressure indexes with alterations in effective seat tube angle
Reece McDonald1, Wendy Holliday1, Jeroen Swart1
1Department of Human Biology, Faculty of Health Sciences, University of Cape Town, South Africa.
Abstract:
Alteration of the effective seat tube angle (ESTA) may affect muscle activation patterns of the lower limbs in cycling. There is conflicting evidence due to inadequate kinematic controls in previous studies. The primary aim of this study was to determine the muscle activity of seven lower limb muscles during alterations of the ESTA by altering the position of both the handlebars and saddle forwards or backwards by 3 cm while ensuring controlled kinematics. Secondly, to determine the effect on the saddle pressure indexes. Ten participants performed two 5 min electromyography (EMG) trials at 70% of peak power output (PPO) for three consecutive visits. There was a significant increase in muscle activity in the biceps femoris, gluteus maximus, and medial gastrocnemius with reductions in ESTA while a significant increase in tibialis anterior with increases in ESTA was observed. Saddle pressure indices demonstrated a significant change in frontal versus back pressure as well as mean pubic pressure with changes in ESTA. Alteration in the ESTA affects muscle activity in some, but not all of the lower limb muscles. Further research needs to be conducted to adequately understand the mechanism behind the differences in muscle activation.
More Related Videos
14:52Computerized Dynamic Posturography for Postural Control Assessment in Patients with Intermittent Claudication
Published on: December 11, 2013
08:40Quantifying Arms and Legs Contributions during Repetitive Electrically-Assisted Sit-To-Stand Exercise in Paraplegics: A Pilot Study
Published on: November 11, 2022
Related Concept Videos
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Normal and Tangetial Components: Problem Solving