Related Experiment Video
Updated: Sep 5, 2025

Laboratory-determined Phosphorus Flux from Lake Sediments as a Measure of Internal Phosphorus Loading
Published on: March 6, 2014
[Chemical Forms and Spatial Distribution of Phosphorus in the Sediment of Sihe River]
Zi-Han Zhang1, Xin-Ru Zhang1, Chuan-Xing Jia1,2
1School of Life Science, Qufu Normal University, Qufu 273165, China.
Abstract:
Based on the study of the content, forms, and spatial distribution of phosphorus (P) in the surface and columnar sediments of the Sihe River, the relationships between the total phosphorus (TP) and various forms of P and the basic physical and chemical properties of sediment and their ecological significance were deeply discussed. The forms of P in the sediment were defined including soluble and loosely bound P (S/L-P), Al-bound P (Al-P), Fe-bound P (Fe-P), reductant soluble P (RS-P), Ca-bound P (Ca-P), and residual P (RES-P) using the method of selectively sequential extraction. The results indicated that ω (TP) was 421.84-1188.65 mg·kg-1 in the surface sediment. Among the six forms of P, the content of Ca-P was the highest, accounting for more than 40% of TP, followed by the content of Fe-P, accounting for more than 20% of TP. The content of S/L-P was the lowest, which only accounted for approximately 0.4% of TP. The contents of TP and various forms of P in the surface sediments of the downstream area of the Sihe River were higher than those of the upstream area of the river, which was induced by the discharge of industrial wastewater and domestic sewage in the urban areas nearby the downstream portion of the Sihe River. The contents of TP in the upper samples of the two sediment profiles were obviously higher than those in the bottom samples, indicating that the P pollution in the water environment of the Sihe River has been intensifying in recent years. Among all forms of P in the sediment profiles, Ca-P accounted for the largest proportion, followed by Res-P. The correlation analysis results showed that significant correlations were observed between Fe and Fe-P, Al and Al-P, Ca and Ca-P, and TOC and RS-P in the surface sediments; the same correlations had not been found in the sediment profiles. The calculated results of Fe and TP molar ratio indicated that the sediments of the Sihe River could further accumulate P. The percentage of bioavailable P (BAP) in sediment was 25%-50%.
More Related Videos
06:42Measuring Phosphorus Release in Laboratory Microcosms for Water Quality Assessment
Published on: July 22, 2019
08:21Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
Published on: May 18, 2018
Related Concept Videos
The Phosphorus Cycle
Factors Affecting Solubility
Roles of Electrolytes: Calcium and Phosphate
The calcium concentration in blood plasma is primarily...
Phosphoinositides and PIPs
Different phosphoinositides are synthesized and recruited on the cytosolic face of the plasma membrane. The localization of specific phosphoinositides concentrated in separate membrane...
Molecular Geometry and Dipole Moments
Experimental Determination of Chemical Formula