A novel technology for preparing the placebos of vortioxetine hydrobromide tablets using LCD 3D printing

This study aimed to describe the use of liquid crystal display (LCD) three-dimensional (3D) printing technology to prepare moulds for vortioxetine hydrobromide (VOR) tablet placebos and provide an economical, convenient, and flexible method for the small-batch preparation of special-shaped, scored, and coated placebo tablets. First, LCD 3D printing was used to generate different placebo moulds of VOR tablets based on VOR tablet digital models subtracted from the digital models of cuboid moulds by Boolean operation to optimise the structures of moulds. The better placebo mould had a parting surface located at the 7/10 height of the packing cavities and the positioning columns and slots were three pairs, and the efflux space had slender efflux channels combined with wide efflux tanks. Next, the placebo mould was corrected by the dimensional compensation method due to the shrinkage rates of the packing cavities (2.42%) and placebo prescription (1.12%) and the thickness of the film coating (25.08 μm). The placebo prescription was 8% hydroxypropyl methylcellulose (SH K15M) hydroalcoholic gel, and its mass ratio to lactose was 0.8:2. The placebos were coated with 13% gastric-soluble film coating solution for 30 min and polished with the 30% PEG 4000 solution. The National Bureau of Standards value between the VOR tablets and their placebos was 1.22 ± 0.10 (less than1.5). Finally, the mass of the placebos was similar to that of the VOR tablets. Their dimensional differences were less than 0.1 mm. Their mass, colour, odour, shape, and texture were all similar, which were assessed by manual evaluation. In conclusion, the preparations of VOR tablet placebos can be applied in placebo-controlled trials, and LCD 3D printing has an extensive application value in preparing placebo tablets.