Related Experiment Video
Updated: Sep 4, 2025

Transmission of Multiple Signals through an Optical Fiber Using Wavefront Shaping
Published on: March 20, 2017
Demonstration of turbulence mitigation in a 200-Gbit/s orbital-angular-momentum multiplexed free-space optical link
Abstract:
We experimentally demonstrate turbulence mitigation in a 200-Gbit/s quadrature phase-shift keying (QPSK) orbital-angular-momentum (OAM) mode-multiplexed system using simple power measurements for determining the modal coupling matrix. To probe and mitigate turbulence, we perform the following: (i) sequentially transmit multiple probe beams at 1550-nm wavelength each with a different combination of Laguerre-Gaussian (LG) modes; (ii) detect the power coupling of each probe beam to LG0,0 for determining the complex modal coupling matrix; (iii) calculate the conjugate phase of turbulence-induced spatial phase distortion; (iv) apply this conjugate phase to a spatial light modulator (SLM) at the receiver to mitigate the turbulence distortion for the 1552-nm mode-multiplexed data-carrying beams. The probe wavelength is close enough to the data wavelength such that it experiences similar turbulence, but is far enough away such that the probe beams do not affect the data beams and can all operate simultaneously. Our experimental results show that with our turbulence mitigation approach the following occur: (a) the inter-channel crosstalk is reduced by ∼25 and ∼21 dB for OAM +1 and -2 channels, respectively; (b) the optical signal-to-noise ratio (OSNR) penalty is <1 dB for both OAM channels for a bit error rate (BER) at the 7% forward error correction (FEC) limit, compared with the no turbulence case.
More Related Videos
14:18Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements
Published on: February 28, 2016
07:56A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference
Published on: September 5, 2019
Related Concept Videos
Transmission Line Design Considerations
Propagation Speed of Electromagnetic Waves
Bus Impedance Matrix
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...
Power Factor Correction