Comparison of physical and mechanical properties of three different restorative materials in primary teeth: an in...

Physical and mechanical properties of three different (Ketac Molar Easymix, Dyract XP, Cention N (CN)) restoratives with different ingredients were evaluated.

Four groups were obtained; Group 1: CN LightCure, Group 2: CN SelfCure, Group 3: Ketac Molar Easymix and Group 4: Dyract XP. Disk-shaped samples (n = 10) were prepared and evaluated for the surface roughness test using a profilometer. For the flexure strength test, 2 × 2 × 25 mm bar-shaped samples (n = 10) were prepared, and a three-point bending test was applied to the samples. After preparing cavities for microleakage tests, teeth were restored with restoratives, immersed in dye, and microleakage was assessed. For the microtensile bond strength (µTBS) test, ten sticks were obtained for each group and were stressed under tension.

According to surface roughness tests, CN SelfCure showed the lowest value (0.13 μm), while Ketac Molar Easymix showed the highest value (0.28 μm), and significant differences were found between the groups. In flexural strength tests, the highest values were seen in CN SelfCure (82.94 MPa), with statistically significant differences between the groups. When CN SelfCure was applied with an adhesive, the teeth showed statistically decreased leakage than other groups on the gingival side. Higher leakage values were seen on the gingival side than the occlusal side in most groups, and the SelfCure groups showed decreased leakage than the LightCure groups. According to µTBS tests, the highest value was obtained in CN SelfCure-Adhesive group, while the lowest was in CN LightCure-Non-adhesive group. When µTBS was evaluated regardless of adhesive use, the SelfCure groups showed higher µTBS values than the LightCure groups. As a result of the µTBS and microleakage test, the difference between the use of CN with and without adhesive, regardless of the polymerization type, was found to be significant (p  < 0.05).

Cention N showed better properties in SelfCure mode, compared to the rest materials tested, but further in vitro and in vivo studies are needed to investigate the effect of different polymerization modes and the oral environmental conditions.