Related Experiment Video
Updated: Sep 3, 2025

Reservoir Condition Pore-scale Imaging of Multiple Fluid Phases Using X-ray Microtomography
Published on: February 25, 2015
Enhanced semi-volatile DNAPL accessibility at sub-boiling temperature during electrical resistance heating in
Di Zheng1, Zhuning Geng1, Wan Huang1
1School of Environment and State Key Joint Laboratory of Environment Simulation and Pollution Control, Tsinghua University, Beijing 100084, PR China.
Abstract:
Successful remediation of semi-volatile contaminants using electrical resistance heating (ERH) coupled technologies requires a deep understanding of contaminant migration and accessibility, especially with stratigraphic heterogeneity and dense nonaqueous phase liquid (DNAPL) occurrence. Here, we chose nitrobenzene (NB) as a model contaminant of semi-volatile DNAPL and uniquely demonstrated that temperature variation during ERH could induce NB DNAPL migration out of the low permeability zone (LPZ) even below water boiling temperature. When heating the system using alternating current (AC) of 140 V to a temperature range of 50-79 °C, obvious DNAPL migration was visually observed. The upward migration of DNAPL would considerably increase the mass of accessible contaminant by other remediation measures. The downstream cumulative NB mass of 1092 mg in 140 V system raised 56-folds compared to that of 19 mg in the control experiment with only groundwater flow. This migration was mainly attributed to a complex natural convection caused by temperature gradient. Comparing with traditional AC heating, ERH powered by pulsed direct current (PDC-ERH) showed a higher and more uneven heating pattern, resulting in a stronger convection at the same voltage that enhanced the DNAPL migration out of LPZ. These results revealed the importance of natural convection in the ERH process, which could be further optimized to improve the energy efficiency of remediation.
Related Concept Videos
Diversity of Archaea IV
Specific Heat
For example, increasing the temperature of one gram of water by 1°C requires one calorie of heat energy and can be written as 1 cal/g-°C, or...

