Related Experiment Video
Updated: Sep 3, 2025

Interactive Molecular Model Assembly with 3D Printing
Published on: August 13, 2020
Generative Design and Integrated 3D Printing Manufacture of Cross Joints
Leyu Han1, Wenfeng Du1,2, Zhuang Xia1
1Institute of Steel and Spatial Structures, College of Civil Engineering and Architecture, Henan University, Kaifeng 475004, China.
Abstract:
The integrated process of design and fabrication is invariably of particular interest and important to improve the quality and reduce the production cycle for structural joints, which are key components for connecting members and transferring loads in structural systems. In this work, using the generative design method, a pioneering idea was successfully realized to attain a reasonable configuration of the cross joints, which was then consecutively manufactured using 3D printing technology. Firstly, the initial model and generation conditions of a cross joint were constructed by the machine learning-based generative design algorithm, and hundreds of models were automatically generated. Then, based on the design objective and cost index of the cross joint, three representative joints were selected for further numerical analysis to verify the advantages of generative design. Finally, 3D printing was utilized to produce generative joints; the influences of printing parameters on the quality of 3D printing are further discussed in this paper. The results show that the cross joints from the generative design method have varied and innovative configurations and the best static behaviors. 3D printing technology can enhance the accuracy of cross joint fabrication. It is viable to utilize the integrated process of generative design and 3D printing to design and manufacture cross joints.
Related Concept Videos
Design Example: Joints in Concrete Pavements
Contraction joints are typically formed by sawing a groove into the concrete shortly after it has hardened. This creates a weakened vertical plane, deliberately encouraging cracking at...
Types of Building Separation Joints
Volume-change joints address the effects of expansion and contraction due to temperature and moisture variations. They are strategically placed at discontinuities in a building's mass where cracking is most likely and are spaced about 150 to 200...
Design of Prismatic Beams for Bending
Thin-Walled Hollow Shafts
Plastic Deformation in Circular Shafts
Method of Joints
Since plane truss members are in the same plane, each joint is subjected to a coplanar and concurrent force system. To apply the method of joints, the first step is to...

