Experimental Study on the Properties of Mortar and Concrete Made with Tunnel Slag Machine-Made Sand

Machine-made sand is gradually replacing natural sand to achieve sustainable development. Experimental studies and gray-correlation analysis were used to study the properties of tunnel slag machine-made mortar and concrete. The properties of machine-made mortar with different stone powder content were analyzed through experiments. By analyzing the performance of machine-made sand concrete with equal amounts of cement replaced by stone powder, the optimum replacement ratio is obtained. Gray-correlation analysis was used to compare the degree of influence of fineness modulus and stone powder content on the performance of concrete. Scanning electron microscopy (SEM) and X-ray diffractometry (XRD) were used to analyze the microstructure of tunnel slag sand concrete. The test results showed that the flexural and compressive strengths of the machine-made sand concrete were greater than the standard sand with the same stone powder content. The 28-day flexural and compressive strengths had a maximum difference of more than 30%. The best stone powder content of the machine-made mortar is in the range of 5% to 8%. When the replacement cement content of stone powder is about 6%, the mechanical and working properties of machine-made sand concrete achieve the optimal state. The lower the stone powder content, the closer the mechanical and working properties of machine-made sand concrete and river sand concrete. The correlation between the performance of machine-made sand concrete and fineness modulus is the largest. When the stone powder content is low, it has almost no effect on the compressive strength of concrete. The results point out the direction for the quality control of tunnel slag machine-made sand concrete.