Characteristics of Gaseous/Liquid Hydrocarbon Adsorption Based on Numerical Simulation and Experimental Testing

Hydrocarbon vapor adsorption experiments (HVAs) are one of the most prevalent methods used to evaluate the proportion of adsorbed state oil, critical in understanding the recoverable resources of shale oil. HVAs have some limitations, which cannot be directly used to evaluate the proportion of adsorbed state oil. The proportion of adsorbed state oil from HVA is always smaller than that in shale oil reservoirs, which is caused by the difference in adsorption characteristics of liquid and gaseous hydrocarbons. The results of HVA need to be corrected. In this paper, HVA was conducted with kaolinite, an important component of shale. A new method is reported here to evaluate the proportion of adsorbed state oil. Molecular dynamics simulations (MDs) of gaseous/liquid hydrocarbons with the same temperature and pressure as the HVAs were used as a reference to reveal the errors in the HVAs evaluation from the molecular scale. We determine the amount of free state of hydrocarbons by HVAs, and then calculate the proportion of adsorbed state oil by the liquid hydrocarbon MD simulation under the same conditions. The results show that gaseous hydrocarbons adsorptions are monolayer at low relative pressures and bilayer at high relative pressures. The liquid hydrocarbons adsorption is multilayer adsorption. The adsorption capacity of liquid hydrocarbons is over 2.7 times higher than gaseous hydrocarbons. The new method will be more effective and accurate to evaluate the proportion of adsorbed state oil.