Influence of the Flowable Resin Layer on Bond Strength Between Resin Cement and a Universal Adhesive Applied in the...

The present study evaluated the influence of a flowable resin layer on bond strength between resin cement and a universal adhesive applied using an immediate dentin sealing (IDS) technique.

Coronary portions of bovine teeth were randomly divided into six groups (n=15). In the IDS.U group, the exposed dentin was immediately sealed with the Single Bond Universal adhesive (3M ESPE) following the self-etching protocol. In the IDS.UF group, a layer of Filtek Z350 (3M ESPE) flow resin was applied over the universal adhesive. In the DDS (control) group, the dentin was kept "fresh" and delayed dentin sealing was performed. After 24 hours in distilled water at 37°C, dentin surfaces were treated with pumice, phosphoric acid, and the application of the universal adhesive in the IDS.U and IDS. UF groups. The DDS group was treated with pumice and the universal adhesive was applied. The samples received cylinders of resin cement Rely X Ultimate (3M ESPE) made with the aid of starch tubes of 0.96 mm in diameter and 2 mm in length. They were submitted to the microshear bond strength test (μSBS) at 0.5 mm/min, after 24 hours (T1) and 3 months (T2). The fracture areas were evaluated qualitatively using a DSM 300 microscope (KOZO) with 45× magnification and classified as: adhesive, cohesive in cement, cohesive in dentin, or mixed. Samples were analyzed by scanning electron microscopy (SEM). The data were compared statistically between groups using the Kruskal-Wallis test, and intra-groups using the Mann-Whitney test (α=0.05).

There were no significant differences between groups for the bond strength values (p>0.05). The IDS.UF group showed higher values at 3 months, when compared to the values of 24 hours (p<0.001). All groups showed a predominance of adhesive fracture (86.7% to 100%). SEM showed dentinal tubules exposed in the IDS.U and DDS groups; in the IDS.UF group, the tubules were completely sealed.

The flow resin can be used on the adhesive when using the IDS technique because it increased the bond strength values after 3 months and promoted effective sealing of the dentinal tubules.