Related Experiment Video
Updated: Sep 2, 2025
Biotribological Testing and Analysis of Articular Cartilage Sliding against Metal for Implants
Published on: May 14, 2020
Influences of variability and uncertainty in vertical and horizontal surface roughness on articular cartilage
JinJing Liao1, Xuanchi Liu1, Saeed Miramini1
1Department of Infrastructure Engineering, The University of Melbourne, Parkville, Victoria, Australia.
Background And Objectives:
Cartilage surface roughness has significant implications on joint lubrication. However, the effects of the variability in surface roughness in different directions (especially in horizontal direction) in mixed-mode lubrication have not been fully investigated and relevant research work in this field is limited. This study presents a probabilistic numerical approach to investigate the influence of variability and uncertainty of Root-Mean-Square (RMS) roughness heights (vertical roughness) and roughness correlation lengths (horizontal roughness) on cartilage lubrication.
Methods:
The synthetic surface topographies with typical ranges of vertical and horizontal roughness characteristics were firstly input to a coupled cartilage contact model. A response surface was then constructed using the input roughness parameters and the output coefficient of friction (CoF). Finally, a large number of independent or correlated roughness samples were generated for computing the probability of mixed-mode lubrication failure (PoF), which was defined as CoF > 0.27 (corresponding to a 90% loss of fluid support in the contact interface).
Results:
Both independent RMS roughness heights and correlation lengths are correlated positively with CoF. This indicates that the increase of the vertical surface roughness could exacerbate cartilage wear, whereas increasing surface roughness in horizontal direction (i.e., reducing correlation lengths) could retain gap fluid that aids mixed-mode lubrication. Importantly, it shows that CoF is dominant by RMS roughness height. The uncertainty in the independent correlation lengths may lead to the underestimation of PoF. By simulating osteoarthritic surface roughness with a strong correlation between RMS roughness heights and correlation lengths, the value of PoF could reach 70-99%.
Conclusion:
This study highlights the significance of incorporating the mutual relations between the surface roughness in vertical and horizontal directions into research, and the findings could potentially contribute to the design of biomimetic cartilage surfaces for the treatment of osteoarthritis.
More Related Videos
09:48A Friction Testing-Bioreactor Device for Study of Synovial Joint Biomechanics, Mechanobiology, and Physical Regulation
Published on: June 2, 2022
08:06Addressing Practical Issues in Atomic Force Microscopy-Based Micro-Indentation on Human Articular Cartilage Explants
Published on: October 28, 2022
Related Concept Videos
01:23Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular...
01:21Characteristics of Dry Friction
Before the wheelbarrow starts moving, the static frictional force acts tangentially to the contact surface, opposing the force that is about to induce the motion. This frictional force prevents the...
01:22Surface Tension of Fluid
Surface tension varies...
01:16Structural Joints: Synovial Joints
01:16Surface Tension and Surface Energy
Consider a beaker filled with liquid. The bulk molecules in the liquid experience equal attractive forces on all sides with the surrounding molecules. However, the surface molecules experience a net attractive force downward due to the bulk molecules. The surface of the liquid behaves like a stretched membrane,...
01:27Types of Friction Problems
The first type of dry friction problem involves situations where there is no apparent impending motion....