Valorisation of residual iron dust as Fenton catalyst for pulp and paper wastewater treatment

In this work, the performance of residual iron dust (RID) from metallurgic industry was assessed as Fenton catalyst for the treatment of real pulp bleaching wastewater. The focus was on the removal of recalcitrant pollutants AOX (adsorbable organic halides), by a novel, cleaner, and cost-effective circular solution based on a waste-derived catalyst. The behaviour of RID as iron source was firstly assessed by performing leaching tests at different RID:wastewater w/v ratios and contact time. Afterwards, RID-catalysed homogeneous and heterogeneous Fenton processes were conducted to maximise AOX removal from the pulp bleaching wastewater. Reusability of RID was assessed by a simple collect-and-reuse methodology, without any modification. Similar AOX removal under less consumption of chemicals was achieved with the novel heterogeneous Fenton process. Reaction in the bulk solution was the main pathway of AOX removal, given that the low surface area and porosity of the material did not allow for a high contribution of surface reaction to the overall performance. Moreover, AOX removal was similar over two consecutive treatment cycles, with Fenton process being responsible for 56.7-62.1% removal of AOX from the wastewater, and the leaching step adding 11.4-13.2%. At the end of treatment, COD either decreased (1^st cycle) or remained unchanged (2^nd and 3^rd cycle). The operating cost of the optimised heterogeneous Fenton was 3-11% lower than under conventional Fenton process. This work presented a novel, circular solution based on a low-cost waste-derived catalyst, advancing the knowledge needed to foster industrial application of such technologies to increase industrial environmental performance and efficiency.