Effect of Pre-Anodized Film on Micro-Arc Oxidation Process of 6063 Aluminum Alloy

In the current investigation, micro-arc oxidation (MAO) ceramic coatings on aluminum are galvanostatically synthesized at various processing stages in an alkaline silicate system. The resultant coatings are systematically investigated in terms of the following respects: The working voltage and surface sparking evolution over the studied course of MAO are recorded by the signal acquisition system and the real-time imaging, respectively; the phase composition, the surface morphology, and the polished cross-section of the coatings are characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM) assisted with an energy-dispersive X-ray spectrometer (EDS), respectively. In particular, with the help of a low-rate increase in working voltage, the evolution of the sparks, the energy consumption, and the microstructure development of aluminum in alkaline silicate electrolyte by pre-anodizing are systematically investigated. The results show that the pre-anodized film can accelerate the evolution process of MAO spark and shorten the reaction process in the early stage of MAO reaction, reducing energy consumption and improving the corrosion resistance of the MAO coating. The γ-Al2O3 phase content after pre-anodized is significantly increased in MAO coatings. In particular, the thicker the pre-anodized film (beyond 8 μm) was broken down and fragmentation thinning in the early stage of the MAO process with the presence of micro discharges. This is due to the fact that the electron transition will be released by the emission of radiative recombination and reveals obvious galvanoluminescence (GL) behavior on the surface of the pre-anodized film. Further, based on the present MAO coating microstructure, a model of coating growth after pre-anodized that evolves over time is proposed.