[Pollution Characteristics and Emission Factors of PCDD/Fs from Iron and Steel Industry]

The pollution level, emission characteristics, and emission factors of PCDD/Fs from a number of steel plants were investigated in a particular province of China. The results showed that the concentration of PCDD/Fs was at a low level and decreased by 1-2 orders of magnitude compared with that in 2005-2019. In detail, the concentrations of PCDD/Fs ranged from 0.003-0.557 ng·m^-3(I-TEQ), and the mean value was 0.165 ng·m^-3 for the sintering process. Moreover, the concentrations of PCDD/Fs ranged from 0.006 to 0.057 ng·m^-3, and the mean value was 0.025 ng·m^-3 for the electric furnace process. In addition, the concentration of PCDD/Fs in the iron and steel industry from 2005 to 2020 increased first and then decreased, especially after the implementation of the new emission standard and the ultra-low emission control of conventional pollutants such as smoke, showing a significant decline. The results of fingerprint analysis showed that 2,3,7,8-TCDF was the largest congener contributing to the mass concentration, and lower chlorinated PCDFs were increased. This result differed from those of previous studies in which highly chlorinated PCDFs and PCDDs dominated, indicating that the generation source of PCDD/Fs had changed. The congener and isomer profiles of PCDD/Fs in flue gas from the sintering process were similar to those in the flue gas from the electric furnace process. Additionally, showing the characteristics of the typical high-temperature thermal process, the de novo synthesis may be the dominant mechanism of formation of PCDD/Fs in the sintering process and electric furnace process. The emission factor was 0.003-0.5 μg·t^-1 (I-TEQ), and the average emission factor was (0.18±0.22) μg·t^-1 for the sintering process. The emission factor was 0.04-0.5 μg·t^-1, and the average emission factor was (0.27±0.23) μg·t^-1 for the electric furnace process. These values were far lower than those of the standard toolkit for identification and quantification of dioxin and furan emissions released by UNEP in 2013 and the emission factors in the dioxin emission inventory of China in 2004. It is suggested that the emission factors of PCDD/Fs in the iron and steel industry of China should be studied and updated.