Related Experiment Video
Updated: Aug 31, 2025
Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants
Published on: May 23, 2020
C1 Lateral Mass Screw Placement Through Endonasal Corridor for Purpose of O-C1 Fusion: Morphometric Analysis in
Jonathan A Forbes1, Paolo Palmisciano1, Daniel McGough2
1Department of Neurosurgery, University of Cincinnati College of Medicine, Cincinnati, Ohio, USA.
Background:
Odontoidectomy may pose some risks for O-C1 and/or C1-C2 instability, with previous authors reporting techniques for endonasal C1-C2 fusion. However, no technique for endonasal O-C1 fusion currently exists. We sought to describe the feasibility of endonasal anterior C1 (AC1) screw placement for endonasal O-C1 fusion.
Methods:
Seven adult cadaveric heads were studied for endonasal placement of 14 C1 screws. Using thin-cut computed tomography (CT)-based "snapshot" neuronavigation assistance, 4 mm x 22 mm screws were placed in the C1 lateral mass using a 0° driver. Post-placement CT scans were obtained to determine site-of-entry measured from C1 anterior tubercle, screw angulation in axial and sagittal planes, and screw proximity to the central canal and foramen transversarium.
Results:
Average site-of-entry was 16.57 mm lateral, 2.23 mm rostral, and 5.53 mm deep to the anterior-most portion of the C1 ring. Average axial angulation was 19.49° lateral to midline, measured at the C1 level. Average sagittal angulation was 13.22° inferior to the palatal line, measured from the hard palate to the opisthion. Bicortical purchase was achieved in 11 screws (78.6%). Partial breach of the foramen transversarium was observed in 2 screws (14.3%), violation of the O-C1 joint space in 1 (7.1%), and violation of the central canal in 0 (0%). Average minimum screw distances from the unviolated foramen transversaria and central canal were 1.97 mm and 4.04 mm.
Conclusions:
Navigation-assisted endonasal placement of AC1 screws is feasible. Additional studies should investigate the biomechanical stability of anterior C1 screw-plating systems, with anterior condylar screws as superior fixation point, compared to traditional posterior O-C1 fusion.
Related Concept Videos
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...