Related Experiment Video
Updated: Aug 30, 2025

Formation of Dispersible Taohong Siwu Tablets
Published on: February 3, 2023
Study of Orally Disintegrating Tablets Using Erythritol as an Excipient Produced by Moisture-Activated Dry
Mizuki Yamada1, Agata Ishikawa1, Shun Muramatsu1
1Department of Physical Chemistry, School of Pharmacy and Pharmaceutical Sciences, Hoshi University, 2-4-41 Ebara, Shinagawa-ku 142-8501, Tokyo, Japan.
Abstract:
Moisture-activated dry granulation (MADG) is an eco-friendly granulation method that uses a small amount of water and insoluble excipients to absorb moisture. MADG is expected to improve productivity and reduce costs. Erythritol, an excipient used for preparing orally disintegrating tablets (ODTs), has poor tabletability and is difficult to form into tablets by conventional methods, such as high-shear granulation (HSG) and direct compression. In this study, we optimized the manufacturing conditions for ODTs to improve the tabletability of erythritol using MADG. The disintegration time of tablets made using the MADG method was approximately one-tenth that of those made using the HSG method, and the hardness was approximately 1.4 times higher. Moreover, MADG could delay disintegration and improve tabletability. We further attempted to optimize the manufacturing conditions using MADG, particularly in terms of the amount of water used. The disintegration time increased as the amount of added water increased. Moreover, water absorption tests revealed that capillary wetting decreased as the amount of water added increased, but the initial wetting did not change. These results suggested that the disintegration time was prolonged because of the increase in granule density and decrease in capillary wetting with the increase in the amount of added water. The hardness of the tablets increased because of the easy deformation of the granules after the addition of up to 3% water; however, when more than 3% water was added, the hardness decreased because of the aggregation of the granules with the excess water. Finally, two-dimensional maps of the effect of the amount of added water and water activity indicated that tablets with a hardness of ≥80 N and a disintegration time of ≤15 s could be produced by adjusting the amount of added water to within the range of 2.2-3.3% and water activity to 0.3-0.53. These results indicate that MADG can improve the tabletability of erythritol and be used for the granulation of ODTs. Tablets with appropriate hardness and disintegration properties can be produced by adjusting the water content to approximately 2.7% and the water activity to approximately 0.4 when producing ODTs with MADG.
More Related Videos
04:28Utilizing an Orally Dissolving Strip for Pharmacological and Toxicological Studies: A Simple and Humane Alternative to Oral Gavage for Animals
Published on: March 23, 2016
05:59An In Vitro Dissolution Determination of Multi-Index Components in Tibetan Medicine Rhodiola Granules
Published on: November 4, 2022
Related Concept Videos
Factors Influencing Drug Absorption: Pharmaceutical Parameters
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Factors Affecting Dissolution: Drug Permeability, Stability and Stereochemistry
Factors Affecting Dissolution: Polymorphism, Amorphism and Pseudopolymorphism
Some polymorphic crystals possess lower aqueous solubility than their amorphous counterparts, leading to incomplete absorption. For instance, the oral suspension of Chloramphenicol, which...
Drug Delivery: Enteral Route
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...