pH regulated potassium ferrate oxidation promotes acetic acid yield and phosphorous recovery rate from waste
Simin Zou1, Yannan Ruan1, Hongbo Liu1
1School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai 200093, China.
Abstract:
To improve the dose efficiency of K2FeO4 in waste activated sludge (WAS) treatment, pH regulation on K2FeO4 pretreatment and acidogenic fermentation was investigated. Four pretreatments were compared, i.e. pH3 + 50 g/kg-TS, pH10 + 50 g/kg-TS, neutral pH + 50 g/kg-TS and neutral pH + 100 g/kg-TS (without pH adjustment). The higher short chain fatty acids (SCFAs) yield and phosphorous dissolution rate was found under the condition of pH 10.0. In pH10 + 50 g/kg-TS, the maximum concentration of SCFAs was 5591 mg-COD/L, which yield was 22.6 times higher than that of the neutral pH + 50 g/kg-TS (237 mg COD/L). The acidogenic fermentation period could be shortened to 5 days and acetic acid accounted for 70 % of SCFAs. Furthermore, PO43--P in the hydrolysate (346.5 mg/L) accounted for 47.59 % of TP, which is easier to be recovered by chemical precipitation. Therefore, a more economical and feasible utilization mode of potassium ferrate was proposed.
Related Concept Videos
Factors Affecting Solubility
Polyprotic Acids
Titration of a Polyprotic Acid
Titration of Polyprotic Acids with a Strong Base
Titration of a Weak Acid with a Strong Base
Titration Calculations: Weak Acid - Strong Base
For the titration of 25.00 mL of 0.100 M CH3CO2H with 0.100 M NaOH, the reaction can be represented as:


