Related Experiment Video
Updated: Aug 30, 2025
3D Planning and Printing of Patient Specific Implants for Reconstruction of Bony Defects
Published on: August 4, 2020
Novel application of 3D printed microporous prosthesis to repair humeral nonunion with segmental bone defects: a case
Weipeng Qiu1,2, Bingchuan Liu1,2, Xingcai Li1,2
1Department of Orthopaedics, Peking University Third Hospital, Beijing, China.
Background:
Nonunion of the humeral shaft can turn into bone defects. There is no consensus on the optimal treatment of humeral shaft nonunion with bone defects. Herein, we presented a single case of a patient with a 9.5 cm humerus shaft bone defect treated with a 3D printed Ti6Al4V microporous prosthesis after internal fixation failure of a middle-inferior humerus fracture.
Case Description:
A 53-year-old female who injured her left upper limb by falling was diagnosed with a fracture of the left humeral shaft. The fracture was treated with open reduction and internal fixation. Nine months postoperatively, radiography examination indicated humeral nonunion with a 9.5 cm segmental bone defect. A 3D printing technology was then used to design and fabricate a customized microporous prosthesis with an intramedullary nail and lateral plates. A two-stage surgical strategy was performed, including radical debridement, temporary fixation for the induced membrane formation, and the implantation of the prosthesis. At 18 months of follow-up, encouraging clinical outcomes were observed. The prosthesis remained stable in the original implantation area and callus formation was found at the contact end of the prosthesis and bone stump. The upper limb functions returned to normal with a satisfactory functional score. Also, no complications were found.
Conclusions:
Reconstruction with a 3D printed microporous prosthesis might be used as an alternative for the repair of large segmental bone defects of limbs.
