Related Experiment Video
Updated: Aug 30, 2025

Advanced Self-Healing Asphalt Reinforced by Graphene Structures: An Atomistic Insight
Published on: May 31, 2022
[Effects of attapulgite addition on soil evaporation and crack characteristics]
Ting Yang1,2, Xu-Guang Xing1,2, Xiao-Yi Ma1
1College of Water Resources and Architectural Engineering, Northwest A&F University, Yangling 712100, Shaanxi, China.
Abstract:
Water is one of the most important factors limiting vegetation recovery and agricultural development in arid and semi-arid areas. The reduction of ineffective soil evaporation can improve soil water use efficiency. As a kind of clay mineral, attapulgite (ATP) plays a critical role in limiting soil evaporation due to its hydrophilicity and adsorption. In this study, three typical soils with different textures (dark loessial soil, cultivated loess soil, and sandy soil) were selected from the arid and semi-arid area of the Loess Plateau, and five ATP additions (0%, 1%, 2%, 3% and 4%) were set for conducting soil evaporation experiments under natural conditions using micro-evaporators to investigate the effects of ATP addition on different soil evaporation processes and the characteristics of evaporation surface cracks. The results showed that the cumulative evaporation and evaporation loss ratio of the same soil decreased with the increases of ATP addition when the ATP addition was <3%. When ATP was added at 3%, the cumulative evaporation and evaporation loss ratio of dark loessial soil and sandy soil decreased, while those of cultivated loess soil increased. When ATP was added at 4%, the cumulative evaporation decreased and the evaporation loss ratio increased for dark loessial soil, the cumulative evaporation increased and the evaporation loss ratio decreased for sandy soil, and the cumulative evaporation and evaporation loss ratio decreased for cultivated loess soil. The average cumulative evaporation of different soils followed an order of dark loessial soil > cultivated loess soil > sandy soil. Soil water content of ATP treatment was consistently higher than that of control throughout the whole evaporation process in the same soil. Simulations of cumulative evaporation versus the square root of time indicated that the amount of water released from the ATP-treated soil samples at the end of evaporation was higher than that of the control. After the addition of ATP, the crack area density of dark loessial soil and cultivated loess soil increased significantly, and the crack area density of sandy soil increased with the increase of ATP addition. The crack area density of all three soils reached the maximum at 4% of ATP addition. In summary, ATP addition of 3% could minimize the ineffective evaporation of soil water.
More Related Videos
13:27Exploring the Effects of Atmospheric Forcings on Evaporation: Experimental Integration of the Atmospheric Boundary Layer and Shallow Subsurface
Published on: June 8, 2015
07:21Author Spotlight: Advancing Agricultural Land Ecosystem Research with a Hydraulic Property Analyzer to Assess Soil Health
Published on: August 9, 2024
Related Concept Videos
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Unsoundness of Aggregate due to Volume Change
Microcracking in Concrete
Adaptations that Reduce Water Loss
Porosity in Cement Paste
The balance of water to cement in the mix is...
Effects of Air-entrainment in Concrete