Surgical Accuracy of 3D Virtual Surgery and CAD/CAM-Assisted Orthognathic Surgery for Skeletal Class III Patients

Orthognathic surgery is an effective surgical method to achieve functionality and facial esthetics for mandibular prognathism. If surgery is performed with a conventional method, errors may occur in the surgical preparation process and the surgical procedures, and there is a limitation in that the accuracy of surgery is determined according to the surgeon's experience and tactual sense. However, with the recent development of three-dimensional (3D) virtual planning and CAD/CAM technology, more 3D and predictable surgical planning and more accurate and time-saving surgery have become possible. The purpose of this study is to evaluate the surgical accuracy of 3D Virtual Surgery, CAD/CAM-Assisted Orthognathic surgery for Skeletal Class III Patients. The study included 18 patients who had undergone orthognathic surgery for skeletal class III malocclusion from January 2020 to December 2021. To evaluate the accuracy of the virtual planning, 3D facial cone-beam computed tomography taken immediately after surgery (T1) and virtual surgery data (Tv) were superimposed in each patient. Landmarks were set on each of the maxillary segment, mandibular distal segment, and left and right mandibular proximal segment, and the difference between T1 and Tv was compared 3D on the x , y , and z -axis. (ΔT: T1-Tv). As a result, the average distance between Tv and T1 at each landmark, all landmarks except for the posterior nasal spine of the maxillary segment showed <1 mm. In particular, the differences across the x and z -axis were very small, while the difference across the y -axis tend to be large. The comparison of the position of each segment in virtual surgery and actual surgery was as follows. It can be seen that all segments were located slightly downward, and the medial pole of the mandibular proximal segment was located posterolateral and the lateral pole was located anteromedial after the actual surgery compared with the virtual planning. It means that the proximal segment was slightly rotated, but the difference was within 1 mm, so it can be considered that the surgery was accurate. Base on this study, orthognathic surgery using 3D virtual surgery planning and CAD/CAM technologies was very accurate. By applying these cutting-edge technologies to clinical practice, it was possible not only to increase the predictability of surgery but also to improve the convenience of surgery. Therefore, it is thought that it will be important for clinicians to make continuous efforts to applicate cutting-edge technologies to be developed in the future to patient diagnosis and surgery.