Related Experiment Video
Updated: Aug 30, 2025

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
Published on: June 3, 2015
Measurement-Induced Power-Law Negativity in an Open Monitored Quantum Circuit
Zack Weinstein1, Yimu Bao1, Ehud Altman1,2
1Department of Physics, University of California, Berkeley, California 94720, USA.
Abstract:
Generic many-body systems coupled to an environment lose their quantum entanglement due to decoherence and evolve to a mixed state with only classical correlations. Here, we show that measurements can stabilize quantum entanglement within open quantum systems. Specifically, in random unitary circuits with dephasing at the boundary, we find both numerically and analytically that projective measurements performed at a small nonvanishing rate result in a steady state with an L^{1/3} power-law scaling entanglement negativity within the system. Using an analytical mapping to a statistical mechanics model of directed polymers in a random environment, we show that the power-law negativity scaling can be understood as Kardar-Parisi-Zhang fluctuations due to the random measurement locations. Further increasing the measurement rate leads to a phase transition into an area-law negativity phase, which is of the same universality as the entanglement transition in monitored random circuits without decoherence.
Related Concept Videos
The Pauli Exclusion Principle
Small-Signal Analysis of MOSFET Amplifiers
Power in an AC Circuit
In a DC circuit, there is no sinusoidal waveform associated with the supply; the voltages and currents...
Biot-Savart Law
A current-carrying wire creates a magnetic field in its vicinity. Consider an infinitesimal current element dl in a wire. The direction of vector dl is along the direction of the current. The total magnetic...
Biot-Savart Law: Problem-Solving
Consider a mobile phone battery bank as a source of steady current, which flows through the wire connected between the two. What is the magnitude of the magnetic field created by this current at a field point P?
To estimate the magnitude of the total magnetic field, we first consider a small current element of length dl, at a distance r from the field point. Now the following...
Power Dissipated in a Circuit: Problem Solving
The simplest combinations of resistors are series and parallel connections. In a series circuit, the first resistor's output current flows into the second resistor's input; therefore, each resistor's current is the same. Thus, the equivalent resistance is the algebraic sum of the resistances. The current through the circuit can be found from Ohm's law and is equal to the...

