Effect of Interfacial Lubrication between Rubber and Metal on Reducing Mixer Chamber Wall Wear in Mixing Process

This paper focused on adding a suitable lubrication effect at the interface between the rubber and mixer chamber wall on reducing the surface wear rate of the mixer chamber wall. In the research process, the contact model between the compound and internal mixer chamber wall was simplified to the pin-on-disc experimental model. The experimental results showed that the friction coefficient and the metal surface wear rate of the mixer chamber were reduced (by approximately 24%) by adding an appropriate amount of antifriction agent in the mixing process, while the comprehensive properties of the compound showed an improvement trend. By analyzing the surface elements of the rubber compound, the MoS₂ with an anti-wear effect on the surface of the rubber compound can form a lubrication mechanism between the rubber, filler, and mixer chamber wall metal. Combined with the result of the comprehensive properties of rubber, which showed that although the appropriate amount of antifriction agent formed a lubrication protection mechanism between the rubber and the inner mixing chamber wall, the mechanism did not affect the friction behavior required for mixing. The study can effectively enhance the effective friction mixing and reduce the wear and power consumption of the mixing chamber caused by excess friction during the mixing process.