Related Experiment Video
Updated: Aug 29, 2025

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Strength of Coarse-Grained Soil Stabilized by Poly (Vinyl Alcohol) Solution and Silica Fume under Wet-Dry Cycles
Zhewei Zhao1,2, Wenwei Li3, Haiping Shi1,2
1Water Conservancy Civil Engineering College, Tibet Agriculture and Animal Husbandry University, Linzhi 860000, China.
Abstract:
To investigate an environmentally benign stabilizer for coarse-grained soil in southeast Tibet, poly (vinyl alcohol) (PVA) and silica fume were used to improve the geotechnical properties of coarse-grained soil. Unconfined compressive strength (UCS) and wet-dry cycle tests were conducted on prepared samples to evaluate the effect of the additive content and curing age on the strength and durability of coarse-grained soil. The results reveal that the UCS of the samples increased with the additive content of PVA solution and the curing age. The optimal value for the additive content of PVA solution and the curing age is 12% and 7 days, respectively. With the optimal PVA solution content, the PVA solution combined with silica fume stabilizer exhibited better reinforcement compared with pristine PVA. The UCS of the samples stabilized by PVA solution and silica fume increased depending on the curing age, and plateaued after 14 days. Samples with 12% PVA solution and 6% silica fume achieved a satisfactory UCS of 1543.17 kPa after curing for 28 days. As the number of wet-dry cycles increased, the UCS of the samples stabilized by the PVA solution and silica fume exhibited an upward trend during the first three wet-dry cycles, owing to the filling of pores by the gel produced by the silica fume, but began to decline as the number of wet-dry cycles increased. All samples retained a high UCS value after 10 wet-dry cycles compared with the samples that were not subjected to wet-dry cycles.
Related Concept Videos
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Pozzolans
Fly ash is...
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Hydration of Cement
Fineness of Cement
Direct...

