Electromigration Dispersion in Sodium Dodecyl Sulfate Capillary Gel Electrophoresis of Proteins

The electromigration dispersion of the light- and heavy-chain subunit peaks of the therapeutic monoclonal antibody omalizumab was investigated in sodium dodecyl sulfate capillary gel electrophoresis (SDS-CGE) using borate cross-linked dextran sieving matrices. Increasing boric acid content (340-640 mM) caused electromigration dispersion shifts for both low (2%)- and high (10%)-dextran-concentration gels in all gel-buffer compositions. In case of the heavy-chain fragment, elevated borate concentrations resulted in decreasing tailing and increasing fronting with the use of higher- and lower-dextran-concentration gels, respectively. The light-chain fragment, on the other hand, exhibited increased fronting with increasing borate concentration for both dextran concentrations examined in this study. Increase of the glycerol ingredient level in the gel-buffer system caused the same effect as the increasing borate concentration in both dextran concentrations. The detected electromigration dispersion was considered as the result of the formation of monomeric and dimeric glycerol-borate complexes as co-ionic constituents, migrating slower than that of the unconjugated tetrahydroxyborate. In addition, complexation of the tetrahydroxyborate anion with the glucose building blocks of the dextran polymer decreased its mobility to practically zero, contributing to further decrease in the resultant effective mobility of the co-ionic species. We suggest that the observed fronting and/or tailing peak shapes of the monoclonal antibody fragments in SDS-CGE at increasing boric acid concentrations can be considered as the result of multiple effects including changes in pH, sieving matrix pore size, viscosity, and the mobility variation of the co-ionic borate adducts with the gel-buffer ingredients. While electromigration dispersion-mediated band broadening, in general, can be minimized via matching the effective mobility of the co-ionic species to the analyte molecules of interest, in case of borate cross-linked dextran gels, optimization of the boric acid concentration required special consideration of its gel cross-linking function. For the light- and heavy-chain fragments of the IgG analyte, best peak shapes were attained with the use of 10% dextran/340 mM boric acid and 10% dextran/640 mM boric acid-containing gel-buffer systems, respectively. Based on this observation, here we introduce the concept of borate-gradient-mediated transient mobility matching in SDS-CGE of proteins. This novel approach resulted in close to optimal peak shapes for the distantly migrating IgG subunits within a single run, as well as unraveled the long-sought possible solution to perform capillary pore-size-gradient gel electrophoresis.