Related Experiment Video
Updated: Aug 29, 2025
3D Printing of Preclinical X-ray Computed Tomographic Data Sets
Published on: March 22, 2013
Three-dimensional printer use in the Australian and New Zealand radiation therapy setting
Christine E Albantow1, Savannah J Brown2
1Crown Princess Mary Cancer Centre, Westmead Hospital, Westmead, New South Wales, Australia.
Introduction:
This cross-sectional survey aimed to collect data from radiation therapy departments around Australia and New Zealand to establish a baseline of 3D printer and product use.
Methods:
Each department in Australia and New Zealand was contacted to determine the most appropriate person to answer the survey. A Microsoft Forms link to the survey was sent to the individual. The survey contained 47 questions in relation to what 3D printing device departments had (if any), how it was being utilised, and what 3D printed products were in use.
Results:
A total of 112 departments completed the survey (100% response rate), with 22.3% reporting 3D printer ownership, and thirty-four departments (30.4%) outsourcing 3D printed products. The primary use of 3D printers was bolus production (60.9%). Public departments represented 84% of printer ownership, while private departments were the greatest users of outsourced 3D printed products (91.4%). 3D Slicer was the most common software used for Digital Imaging and Communications in Medicine (DICOM) file conversion (42.3%), while polylactic acid (PLA) and acrylonitrile butadiene styrene (ABS) were the most common filaments in use, 46% and 14%, respectively.
Conclusion:
This research established a baseline for 3D printer and product use within the Australian and New Zealand radiotherapy setting.
