Accretion of the cratonic mantle lithosphere via massive regional relamination

Zhensheng Wang1, Fabio A Capitanio1,2, Zaicong Wang1

  • 1State Key Lab of Geological Processes and Mineral Resources, Center for Global Tectonics, School of Earth Sciences, China University of Geosciences, Wuhan, 430074 China.

Related Concept Videos

Recrystallization: Solid–Solution Equilibria01:10

Recrystallization: Solid–Solution Equilibria

Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
1.2K
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
567
Cell Motility through Blebbing01:16

Cell Motility through Blebbing

Blebs are a type of membrane protrusion formed by the internal hydrostatic pressure of the cytoplasm. Blebs are observed in several cell types, including fibroblasts, immune cells, and single-celled organisms like the amoeba. The primary function of blebs is cell locomotion and apoptosis, but they are also found during necrosis and cell division. The life cycle of a bleb comprises an initiation phase followed by the expansion and retraction phases.
Blebbing Through the Matrix
In multicellular...
2.0K
Types of Coprecipitation01:10

Types of Coprecipitation

Coprecipitation is the contamination of a precipitate by otherwise soluble species and occurs via different processes. In colloidal precipitates, coprecipitation occurs via surface adsorption. For instance, barium sulfate has a primary layer of adsorbed barium ions and a secondary layer of nitrate counterions. This results in contamination of the precipitate by barium nitrate.
Sometimes, ions in a crystal lattice can undergo isomorphous replacement by inclusions of similar charge and size. For...
811
Region of Convergence of Laplace Tarnsform01:20

Region of Convergence of Laplace Tarnsform

The Region of Convergence (ROC) is a fundamental concept in signal processing and system analysis, particularly associated with the Laplace transform. The ROC represents an area in the complex plane where the Laplace transform of a given signal converges, determining the transform's applicability and utility.
Consider a decaying exponential signal that begins at a specific time. When deriving its Laplace transform, the time-domain variable is replaced with a complex variable. This...
656
Resultant of a General Distributed Loading01:13

Resultant of a General Distributed Loading

While designing structures exposed to non-uniform loads, it is crucial to consider the resultant force and its location. This resultant force is a single vector representing the net force applied due to the distributed load.
Examples such as load distribution due to wind and load distribution on a bridge illustrate how this concept is used to analyze and design safe, reliable structures under variable loading conditions. Most structures, such as residential buildings, bridges, and towers, are...
735