Effect of Scanning Speed on Properties of Laser Surface Remelted 304 Stainless Steel

In order to study the microstructure and properties of stainless steel after laser surface remelting, based on the theory of laser surface remelting, a simulation model of nanosecond-pulsed laser surface remelted stainless steel was established to study the evolution law of the Marangoni force of the molten pool during laser surface remelting. A single-lane laser remelting experiment was performed to study the variation of the scanning speed on the remelting width, roughness, and layer microtopography. The "S" scanning path was used to remelt the stainless steel surface to investigate the bonding force between the remelted layer and the substrate, the hardness, microscopic morphology, and corrosion resistance. The results show that the viscosity of the liquid metal in the molten pool increases with the increase of the scanning speed. Larger liquid viscosity and smaller surface tension temperature gradients promote a weaker flow of liquid metal, which reduces the velocity of the liquid metal flow in the molten pool. With the increase of scanning speed, the remelting width gradually decreases, but the roughness gradually increases. When the element content of Cr increases, the element content of Fe and O decreases. The surface is covered with an oxide film, the main components of which are oxides of Cr and Fe, the remelted layer is greater than that of the substrate, and the corrosion resistance is improved. Laser surface remelting technology can improve the structure and properties of 304 stainless steel.