Pretreatment of Ultra-Weak Fiber Bragg Grating Hydrophone Array Based on Cubic Spline Interpolation Using Intensity...

The demodulation algorithm based on 3 × 3 coupler in a fiber-optic hydrophone array has gained extensive attention in recent years. The traditional method uses a circulator to construct the normal path-match interferometry; however, the problem of increasing the asymmetry of the three-way signal to be demodulated is easily overlooked. To provide a solution, we report a pretreatment method for hydrophone array based on 3 × 3 coupler demodulation. We use cubic spline interpolation to perform nonlinear fitting to the reflected pulse train and calculate the peak-to-peak values of the single pulse to determine the light intensity compensation coefficient of the interference signal, so as to demodulate the corrected three-way interference signal. For experimental verification, ultra-weak fiber Bragg gratings (uwFBGs) with reflectivity of -50 dB are applied to construct a hydrophone array with 800 sensors, and a vibratory liquid column method is set up to generate a low-frequency hydroacoustic signal. Compared to the traditional demodulation algorithm based on a 3 × 3 coupler, the pretreatment method can improve the consistency of interference signals. The Lissajous figures show that cubic spline interpolation can improve the accuracy of monopulse peak seeking results by about 1 dB, and intensity compensation can further lead to a much lower noise density level for the interference pulse amplitude-specifically, more than 7 dB at 5~50 Hz-and the signal-to-noise ratio is improved by approximately 10 dB at 10 Hz. The distinct advantages of the proposed pretreatment method make it an excellent candidate for a hydrophone array system based on path-match interferometry.