Related Experiment Video
Updated: Aug 27, 2025
Author Spotlight: Advancing CBCT and Digital Dental Image Integration with AI-Assisted Digitization
Published on: February 23, 2024
Prevalence and anatomical variations of maxillary sinus septa: A cone-beam computed tomography analysis
Farida Abesi1, Samaneh Motaharinia2,3, Ehsan Moudi3
1Dental Materials Research Center, Department of Oral and Maxillofacial Radiology, Dental Faculty, Babol University of Medical Sciences, Babol, Iran.
Background:
Detailed understanding the anatomy and variations of maxillary sinus septa is necessary. We aimed to investigate prevalence and various anatomical variations of maxillary sinus septa using cone-beam computed tomography (CBCT) images.
Material And Methods:
In this retrospective cross-sectional study, CBCT scans of 809 patients referred to a specialist dental and maxillofacial radiology clinic in Babol, northern Iran, during 2014-2020 were evaluated. Location, morphology, height, and direction of septa in different planes were recorded.
Results:
Sinus septa were observed in 37.9% (n=307) of the participants. There were 117 cases with septa only in left sinus, 83 cases with septa only in right sinus, and 107 cases with septa in both sinuses. Totally, 414 septa were seen in the subjects. Prevalence of partial septa was considerably higher than complete septa (77.5% versus 22.5%). Regarding septa location, middle area with a prevalence rate of 58.7% was found more prevalent than other sinus areas. The mean septum height on the left and right sinuses was 6.0±3.1 mm 5.7±3.9, respectively (p<0.001). Regarding left sinus, directions of vertical (63.8%), oblique (30.8%), and straight (63.8%) were the most prevalent compared with other directions in sagittal, frontal, and axial planes, respectively. In relation to right maxillary sinus, direction of vertical in sagittal and frontal planes (72.6% and 24.2%, respectively), and direction of straight in axial plane (58.4%) were the most prevalent directions compared with others in the same planes.
Conclusions:
Septa prevalence in maxillary sinus was relatively high, with various directions, locations, heights, and shapes. It is recommended to use CBCT for a careful evaluation of toothless area prior to surgeries on the sinus (especially sinus lift) in three plans, in order to take careful measures and prevent postoperative complications in case septa exist. Key words:Maxillary sinus septa, anatomical variation, cone-beam computed tomography, dental implant.
More Related Videos
10:23Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
06:13Endoscopic Septoplasty with Limited Two-line Resection: Minimally Invasive Surgery for Septal Deviation
Published on: June 20, 2018
Related Concept Videos
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:27Imaging Studies III: Computed Tomography