Related Experiment Video
Updated: Aug 27, 2025

Monitoring Pedogenic Inorganic Carbon Accumulation Due to Weathering of Amended Silicate Minerals in Agricultural Soils.
Published on: June 4, 2021
Characterization of fresh PM deposits on calcareous stone surfaces: Seasonality, source apportionment and soiling
Monika Ogrizek1, Asta Gregorič2, Matic Ivančič3
1Department of Analytical Chemistry, National Institute of Chemistry, Hajdrihova 19, 1000 Ljubljana, Slovenia; Jožef Stefan International Postgraduate School, Jamova cesta 39, 1000 Ljubljana, Slovenia.
Abstract:
Particulate matter (PM) pollution is one of the major threats to cultural heritage outdoors. It has been recently implied that organic aerosols will prevail over inorganic carbon particulates in the future, changing the main mechanisms of damage caused by poor air quality to calcareous heritage in particular. We studied fresh particulate deposits on marble and limestone surfaces exposed to urban air in sheltered and unsheltered configurations. Due to different air pollution sources in different seasons, the amount and composition of surface deposits varied throughout the year. The main and most constant contributor to PM2.5 (particles smaller than 2.5 μm) were primary traffic emissions (30 %), followed by secondary formation of acidic inorganic aerosols, such as sulphate in summer and nitrate in winter (33 % altogether), and seasonal biomass-burning emissions (14 %). Although biomass burning is the major source of primary organic aerosols including the light-absorbing fraction that prevailed over black carbon (BC) in colder months (up to 60 % carbonaceous aerosol mass), we show that surface darkening causing the soiling effect is still governed by the minor BC fraction of atmospheric aerosols, which remained below 20 % of the carbonaceous aerosol mass throughout the year. This, however, can change in remote environments affected by biomass-burning emissions, such as winter resorts, or by rigorous BC mitigation measures in the future. In the short run, sheltered positions were less affected by different removal processes, but we show that surface deposits are not simply additive when considering longer periods of time. This must be taken into account when extrapolating surface accumulation to longer time scales.
Related Concept Videos
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Sulfate Attack on Concrete
Sulfates from sources like soil, groundwater, or industrial effluents...
Fineness of Cement
Direct...

