Multi-person movement-induced airflow and the effects on virus-laden expiratory droplet dispersion in indoor environments
Related Experiment Video
Updated: Aug 27, 2025

Detection of Viruses from Bioaerosols Using Anion Exchange Resin
Published on: August 22, 2018
Jialin Wu1,2, Jing Geng1,2, Ming Fu3,4
1Department of Engineering Physics, Tsinghua University, Institute of Public Safety Research, Beijing, China.
Abstract:
The multi-person movement might cause complex induced airflow and affect the virus-laden expiratory droplet transmission in indoor environments. Using the dynamic mesh model in computational fluid dynamics, the multi-person movement with different personnel location distributions was realized. The induced airflow patterns, virus-laden droplet dispersion, and concentration distribution were investigated in detail. The results show that multi-person movement might intensify inter-regional convection, which has been rarely found in single-person movement conditions. Side-by-side distribution and ladder distribution of moving persons could cause a connected low-pressure area behind the moving persons, which might enhance lateral virus transport, especially where droplets might suspend at the height of the breathing zone. Not only 1-10 μm aerosols but also some 20-50 μm droplets are carried by the multi-person movement-induced airflow to over 3 m. Since the width of induced airflow is about 0.6-1.0 m, moving persons should keep enough horizontal distance (>1.0 m) to limit the air mixing and virus-laden droplet transmission. This paper could provide a detailed reference for the numerical study of multi-person movement-induced airflow patterns, droplet dispersion, and indoor infection control.
More Related Videos
Related Concept Videos
Transmission-based Precautions II: Airborne and Protective Environment
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...
Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...
Pulmonary Tuberculosis I
Causative Organism
The primary infectious agent causing tuberculosis is Mycobacterium tuberculosis, a slow-growing, acid-fast, aerobic rod that exhibits sensitivity to heat and ultraviolet light. Instances of Mycobacterium bovis and Mycobacterium avium contributing to the development of TB infection are rare.
Mode of...
Intracellular Movement of Viruses and Bacteria
Transmission-based Precautions I: Contact, Enteric, and Droplets
Contact Precautions:
Contact precautions are the measures taken to prevent the transmission of infectious agents, especially epidemiologically important microorganisms such as MRSA or influenza, primarily transmitted through direct or indirect contact with an...
Viral Recombination

