Nutritive value, silage fermentation characteristics, and aerobic stability of grass-legume round-baled silages at...

For baled silages, production of clostridial fermentation products can be exacerbated by exceeding normal moisture targets (45% to 55%), and/or by the application of dairy slurry before harvest. Our objectives were to test a microbial inoculant as a mitigant of clostridial products in high-moisture, grass-legume (52% ± 13.8% cool-season grasses, 44.0% ± 14.0% legumes [predominately alfalfa]) baled silages in swards that were fertilized with dairy slurry. A secondary objective was to examine the effects of bale moisture and inoculation on the aerobic stability of these fermented silages following exposure to air. After the first-cutting was removed, three manure treatments were applied as a whole-plot factor: 1) control (no manure); 2) slurry applied immediately to stubble (63,250 L/ha); or 3) slurry applied after a 1-wk delay (57,484 L/ha). An interactive arrangement of bale moisture (64.1% or 48.4%) and inoculation (yes or no) served as a subplot term in the experiment. The inoculant contained both homolactic (Lactococcus lactis 0224) and heterolactic (Lactobacillus buchneri LB1819) bacteria. The experimental design was analyzed as a randomized complete block with four replications, and the study included 48 experimental units (1.2 × 1.2-m round bales). Total fermentation acids were affected (P ≤ 0.021) by slurry application strategies, but this was likely related to inconsistent bale moisture across slurry-application treatments. Concentrations of butyric acid were low, and there were no detectable contrasts comparing manure treatments (mean = 0.05%; P ≥ 0.645). Bale moisture affected all measures of fermentation, with bales made at 64.1% moisture exhibiting a more acidic final pH (4.39 vs. 4.63; P < 0.001), less residual water-soluble carbohydrates (2.1% vs. 5.1%; P < 0.001), as well as greater lactic acid (4.64% vs. 2.46%; P < 0.001), acetic acid (2.26% vs. 1.32%; P < 0.001), and total fermentation acids (7.37% vs. 3.97%; P < 0.001). Inoculation also reduced pH (4.47 vs. 4.56; P = 0.029), and increased acetic acid (1.97% vs. 1.61%; P < 0.001) and 1,2-propanediol (1.09% vs. 0.72%; P < 0.001) compared to controls. During a 34-d aerobic exposure period, maximum surface bale temperatures were not affected (P ≥ 0.186) by any aspect of treatment, likely due to the prevailing cool ambient temperatures; however, yeast counts were numerically lower in response to greater (P < 0.001) production of acetic acid that was stimulated by both high bale moisture and inoculation.