Related Experiment Video
Updated: Aug 26, 2025

Multiplex Chemical Imaging Based on Broadband Stimulated Raman Scattering Microscopy
Published on: July 25, 2022
Stimulated Raman scattering spectroscopy with quantum-enhanced balanced detection
Abstract:
Quantum-enhanced stimulated Raman scattering (QE-SRS) is a promising technique for highly sensitive molecular vibrational imaging and spectroscopy surpassing the shot noise limit. However, the previous demonstrations of QE-SRS utilized rather weak optical power which hinders from competing with the sensitivity of state-of-the-art SRS microscopy and spectroscopy using relatively high-power optical pulses. Here, we demonstrate SRS spectroscopy with quantum-enhanced balanced detection (QE-BD) scheme, which works even when using high-power optical pulses. We used 4-ps pulses to generate pulsed squeezed vacuum at a wavelength of 844 nm with a squeezing level of -3.28 ± 0.12 dB generated from a periodically-poled stoichiometric LiTaO3 waveguide. The squeezed vacuum was introduced to an SRS spectrometer employing a high-speed spectral scanner to acquire QE-SRS spectrum in the wavenumber range of 2000-2280 cm-1 within 50 ms. Using SRS pump pulses with an average power of 11.3 mW, we successfully obtained QE-SRS spectrum whose SNR was better than classical SRS with balanced-detection by 2.27 dB.
More Related Videos
09:57Ultrafast Time-resolved Near-IR Stimulated Raman Measurements of Functional π-conjugate Systems
Published on: February 10, 2020
09:46Direct Comparison of Hyperspectral Stimulated Raman Scattering and Coherent Anti-Stokes Raman Scattering Microscopy for Chemical Imaging
Published on: April 28, 2022
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...