Related Experiment Video
Updated: Aug 25, 2025

Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements
Published on: June 25, 2021
Path Loss Measurements and Model Analysis in an Indoor Corridor Environment at 28 GHz and 38 GHz
Tolulope T Oladimeji1, Pradeep Kumar1, Mohamed K Elmezughi1
1Discipline of Electrical, Electronic and Computer Engineering, University of KwaZulu-Natal, Durban 4041, South Africa.
Abstract:
This paper examines the large-scale path loss models for an indoor corridor environment at frequencies of 28 and 38 GHz. The measurement environment consists of an indoor corridor with both line-of-sight (LOS) and non-line of sight (NLOS) scenarios using vertical-vertical (V-V) and vertical-horizontal (V-H) antenna polarizations. The single-frequency close-in (CI), floating intercept (FI), free space large-scale path loss models and measured data from the measurement campaign were used to evaluate the performance analysis. The paper also focuses on various parameters, such as standard deviation, path loss exponent (PLE), accuracy, simplicity, and stability of the models. The analysis focuses on the peculiarity of the effect of the wall proximity on the path loss parameters as well as comparisons with the parameters in some of the reviewed literature studies. The FI and CI models produce comparable results for both antenna polarizations and clearly fit with the measured path loss. The PLE, with the highest value of 3.33 at 38 GHz (V-H), is much higher in the NLOS scenario with V-H polarization due to the signal degradation along the path from the transmitter (Tx) to the receiver (Rx). This is because there is no direct LOS between the Tx and Rx antennas. The Rx only relies on signal diffractions and reflections from obstacles as it transmits through the path from the Tx antenna. The path loss measurements and model analysis presented here are useful in designing 5G wireless communication systems for indoor environments, particularly for power budget calculations.
Related Concept Videos
Propagation Speed of Electromagnetic Waves
Transmission Line Design Considerations
Distance Measurements by Taping
Electronic Distance Measuring Instruments
Design Example: Measuring Distance Between Two Points with Obstructions
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...

