[Design of a New Puncture Needle for Trocar]

To develop a new type of puncture needle for indwelling needle, which can overcome the performance problems of the existing puncture needle, reduce producing cost, and enhance clinical operability.

In this design, solid needle thread is used to replace the traditional hollow pipe thread, three cutting edges are used to replace the existing two cutting edges, and the shaft edge form (the needle tip is on the needle thread's axis) is used to replace the original back blade or edge blade; the slot on the side of the solid core wire is used to replace the hollow and side hole on the traditional pipe. Finally, a new solid core puncture needle is formed by a section of solid core steel wire with a spiral groove, the cross-section of which is a circular slotted needle with a triangular shape at one end. Through the comparative analysis of stiffness mutation and puncture force in the experiment, the characteristics and advantages of new puncture needle are reflected.

The new solid core needle can meet the need of puncture in the course of treatment, and can avoid the potential risk caused by the rigidity mutation of the needle used in the traditional indwelling needle, at the same time, it also has the space to reduce the demand of needle diameter, that means it has the potential to develop smaller needle products.

The new type of trocar puncture needle, from hollow to solid core, can not only meet the basic requirements of puncture and observation of blood return, but also can avoid the risk of traditional puncture needle due to stiffness mutation, the utility model also has the advantages of better performance (less puncture force) and larger expansion space.