Related Experiment Video

Updated: Aug 25, 2025

Crack Monitoring in Resonance Fatigue Testing of Welded Specimens Using Digital Image Correlation
05:30

Crack Monitoring in Resonance Fatigue Testing of Welded Specimens Using Digital Image Correlation

Published on: September 29, 2019

8.3K

Analysis of the RCF crack detection phenomenon based on induction thermography

Xiao Liang, Jianping Peng, Xiang Zhang

    Applied Optics
    |October 18, 2022
    PubMed

    More Related Videos

    Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere08:52

    Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere

    Published on: April 30, 2018

    8.2K
    In Situ Surface Temperature Measurement in a Conveyor Belt Furnace via Inline Infrared Thermography07:03

    In Situ Surface Temperature Measurement in a Conveyor Belt Furnace via Inline Infrared Thermography

    Published on: May 30, 2020

    4.5K

    Related Concept Videos

    Series R—L Circuit Transients01:22

    Series R—L Circuit Transients

    In a series resistor-inductor (R-L) circuit, closing the switch at the start of the time period simulates a three-phase short circuit, a fault condition where all three phases of an unloaded synchronous machine are short-circuited. When there is no fault impedance and no initial current, the initial voltage is determined by the phase angle of the source voltage.
    Using Kirchhoff's Voltage Law (KVL) to analyze this circuit helps determine the total asymmetrical fault current, which consists...
    143
    Gas Chromatography: Types of Detectors-I01:21

    Gas Chromatography: Types of Detectors-I

    There are different types of detectors used in gas chromatography, each with its own specific properties that make it suitable for detecting certain types of analytes. The most commonly used detectors in GC are thermal conductivity detector (TCD), flame ionization detector (FID), and electron capture detector (ECD).
    TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...
    563
    IR Frequency Region: Fingerprint Region01:03

    IR Frequency Region: Fingerprint Region

    IR spectra are divided into two main regions: the diagnostic region and the fingerprint region. The diagnostic region of the spectrum lies above 1500 cm−1. The absorptions resulting from single-bond vibrations of the N–H, C–H, and O–H stretch at higher wavenumbers and appear on the left side of the spectrum. The stretching absorptions of the C≡C and C≡N occur between 2100–2300 cm−1. In contrast, those arising from stretching absorptions of the...
    1.0K