Related Experiment Video
Updated: Aug 23, 2025

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Compaction Curves and Strength of Clayey Soil Modified with Micro and Nano Silica
Abeer W Alshami1, Bashar H Ismael1, Mohammed F Aswad2
1Civil Engineering Department, Al-Maarif University College (AUC), Ramadi 31001, Iraq.
Abstract:
Some Clayey soils are generally categorized as weak soils, and structures lying on such soils have been exposed to severe damage. Therefore, the central thesis of this paper is the impact of a waste material known as a silica fume as nano and micro material on soil's behaviour. To evaluate the effects of those additives on Atterberg limits, compaction characteristics and unconfined compressive strength, clayey soil samples have been transformed using micro and nano silica fume (by-product materials). In the current investigation, silica fume is used at four different percentages: 0, 2, 4, and 7%. The results show that the plasticity index of soil decreases with the addition of micro silica and increases with the addition of nano-silica. Increasing nano silica percentage improves the dry density of the compacted soil and reduces the optimum moisture content. An opposite behavior is observed with adding micro silica to compacted soil. Finally, 4% of silica fume is found to be the optimum dosage to improve the unconfined compressive strength of the treated soil with both additives. As a result, treating the weak clay soil with micro and/or nano-silica fume has the potential to be impactful.
More Related Videos
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
07:32Monitoring Pedogenic Inorganic Carbon Accumulation Due to Weathering of Amended Silicate Minerals in Agricultural Soils.
Published on: June 4, 2021
Related Concept Videos
Relation Between Tensile Strength and Compressive Strength of Concrete
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Fineness of Cement
Direct...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Bonding and Strength of Aggregate
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...