l-Arginine as a Bio-Based Curing Agent for Epoxy Resins: Glass Transition Temperature, Rheology and Latency

The need for sustainable practices in the processing chain of fiber-reinforced thermosets has led to the development of bio-based epoxy resins and curing agents. As a contribution to sustainable composites, this study focuses on the glass transition temperature (Tg), viscosity and latency of diglycidyl ether of bisphenol a (DGEBA) cured with l-arginine in the presence of a urea-based accelerator. These characteristics are decisive features for application as a matrix in fiber-reinforced polymer composites produced via prepreg technology in which low viscosity and sufficient latency, meaning low reactivity of the one-component system, are necessary. The homogeneous mixture of amino acid and epoxy resin was prepared via three-roll milling. Two formulations, Argopox-1 with 1 wt.% accelerator and Argopox-2.5 with 2.5wt.% accelerator, were prepared and parts of each formulation were stored at 22 °C and -18 °C, respectively. Both formulations were tested via differential scanning calorimetry (DSC) and small amplitude oscillatory shear rheology (SAOS) after 0 d, 30 d, 60 d, 90 d and 180 d of storage to determine the influence of accelerator weight fraction, storage temperature and storage period on the glass transition temperature of the uncured resin system Tg0, and their viscosity. The Tg of the thermosets is about 100 °C. The DSC and SAOS measurements show that the Tg0 of Argopox-1 shifts about 5 °C in 60 d, while its viscosity is still low enough to be processed in a prepreg production line. Furthermore, Argopox-1 is storable for at least 180 d at -18 °C without significant changes in its Tg0 and viscosity. Consequently, Argopox-1 possesses a sufficiently high Tg and adequate latency, as well as a low viscosity for application as prepreg matrix material.