Related Experiment Video
Updated: Aug 23, 2025

Large Scale Energy Efficient Sensor Network Routing Using a Quantum Processor Unit
Published on: September 8, 2023
Optimal Achievable Transmission Capacity Scheme for Full-Duplex Multihop Wireless Networks
Aung Thura Phyo Khun1, Yuto Lim1, Yasuo Tan1
1Graduate School of Advanced Science and Technology, Japan Advanced Institute of Science and Technology, 1-1 Asahidai, Nomi City 923-1292, Ishikawa, Japan.
Abstract:
Full-duplex (FD) communication has been attractive as the breakthrough technology for improving attainable spectral efficiency since the 5G mobile communication system. Previous research focused on self-interference cancellation and medium access control (MAC) protocol to realize the FD system in wireless networks. This paper proposes an optimal achievable transmission capacity (OATC) scheme for capacity optimization in the FD multihop wireless networks. In this paper, the proposed OATC scheme considers the temporal reuse for spectral efficiency and the spatial reuse with transmit power control scheme for interference mitigation and capacity optimization. OATC scheme controls the transmit power to mitigate interference and optimizes the transmission capacity, which leads to the optimal achievable network capacity. We conduct the performance evaluation through numerical simulations and compare it with the existing FD MAC protocols. The numerical simulations reveal that considering only the concurrent transmissions in the FD system does not guarantee optimal transmission capacity. Moreover, the hybrid mechanism, including the sequential transmissions, is also crucial because of the interference problem. Besides, numerical simulation validates that the proposed OATC scheme accomplishes the optimal achievable network capacity with lower interference power and higher achievable throughput than the existing MAC protocols.
More Related Videos
Related Concept Videos
Maximum Power Transfer
By substituting the entire circuit with...
Transmission Line Design Considerations
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
Maximum Power Flow and Line Loadability
Mesh Analysis for AC Circuits
The process of harmonizing these impedances begins with a clear understanding of the input and output signals. Once these signals are known, the...
Transmission-Line Differential Equations
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured...

