Related Experiment Video

Updated: Aug 23, 2025

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

6.3K

Intracavity absorption spectroscopy of HCl isotopes, H2O, CH4, C2H4, and C2H6 in the 3.1-3.4 µm spectral range using

Peter Fjodorow, Mikhail P Frolov, Yuri V Korostelin

    Optics Express
    |October 27, 2022
    PubMed

    More Related Videos

    Coulomb Explosion Imaging as a Tool to Distinguish Between Stereoisomers08:51

    Coulomb Explosion Imaging as a Tool to Distinguish Between Stereoisomers

    Published on: August 18, 2017

    10.4K
    Construction and Characterization of External Cavity Diode Lasers for Atomic Physics09:10

    Construction and Characterization of External Cavity Diode Lasers for Atomic Physics

    Published on: April 24, 2014

    27.9K

    Related Concept Videos

    IR and UV–Vis Spectroscopy of Carboxylic Acids01:28

    IR and UV–Vis Spectroscopy of Carboxylic Acids

    In IR spectroscopy of carboxylic acids, the C=O bond shows a characteristic band between 1710 and 1760 cm⁻¹, and the O–H bond exhibits a broad band between 2500 and 3300 cm⁻¹.
    However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency,...
    4.5K
    Atomic Absorption Spectroscopy: Radiation and Light Sources01:13

    Atomic Absorption Spectroscopy: Radiation and Light Sources

    Atomic absorption spectroscopy (AAS) relies on the Beer-Lambert law, which requires that the radiation source emits a narrow range of wavelengths to match the absorption characteristics of the analyte atom. The primary criteria for choosing an appropriate radiation source in AAS is to provide a precise and intense emission at specific wavelengths that will allow accurate detection of the analyte.
    Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...
    479
    Spectroscopy of Carboxylic Acid Derivatives01:26

    Spectroscopy of Carboxylic Acid Derivatives

    Infrared spectroscopy is primarily used to determine the types of bonds and functional groups. In carboxylic acid derivatives, a typical carbonyl bond absorption is observed around 1650–1850 cm−1. For esters, the absorption is recorded at around 1740 cm−1, while acid halides show the absorption at about 1800 cm−1. Another acid derivative, the acid anhydrides, exhibit two carbonyl absorption around 1760 cm−1 and 1820 cm−1, arising from the symmetrical and...
    2.5K
    Atomic Absorption Spectroscopy: Instrumentation01:22

    Atomic Absorption Spectroscopy: Instrumentation

    An atomic absorption spectrophotometer (AAS) comprises several components: a radiation source, an atomizer, a monochromator, and a detector. The radiation source can be a hollow-cathode lamp (HCL) or an electrodeless-discharge lamp (EDL), both of which provide a narrow emission line of the required wavelength. However, some instruments use continuum sources and high-resolution monochromators to achieve a narrow range of radiation.
    The atomizer used in AAS can be either a flame atomizer or an...
    850
    Mass Spectrometry: Alkyl Halide Fragmentation01:22

    Mass Spectrometry: Alkyl Halide Fragmentation

    Chlorine isotopes exist as 35Cl and 37Cl in a 3:1 ratio, while bromine isotopes exist as 79Br and 81Br in a 1:1 ratio. The mass spectrum of alkyl halides typically produces two distinct molecular ion peaks, the molecular ion peak, [M], and the molecular ion plus two, [M + 2] peak. The relative heights of these two peaks are proportional to the isotopic abundance ratios of the halide. For example, 2‐chloropropane and 1‐bromopropane display two peaks with relative peak heights in a 3:1 and...
    1.1K
    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation01:26

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation

    Inductively coupled plasma (ICP) is the common plasma source used in atomic emission spectroscopy (AES), a technique that detects and analyzes various elements in a sample. This method is often called inductively coupled plasma atomic emission spectroscopy (ICP-AES).
    There are three main types of inductively coupled plasma atomic emission spectroscopy  (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used....
    276