Optoelectronic refractometric sensing device for gases based on dielectric bow-ties and amorphous silicon solar cells

The transformation of an hydrogenated amorphous silicon solar cell (aSiH) into an optoelectronic refratometric sensor has been possible through the addition of dielectric bow-tie resonant structures. The indium transparent oxide top electrode is replaced by a thin metallic layer to selectively prevent the direct transmission of light to the active layer of the cell. Then, an array of dielectric bow-tie structures is placed on top of this electrode, to activate the optical absorption through surface plasmon resonance (SPR). The whole device is exposed to the analyte under measure, which is the surrounding medium. Three different dielectric materials with low, medium, and high refractive index were selected for the bow-ties, namely magnesium fluoride (MgF[Formula: see text]), silicon dioxide (SiO[Formula: see text]), and aluminum nitride (AlN) have been tested as coupling structure for SPR excitation. The maximization of the readout/short circuit current has been achieved through the geometrical parameters of such structure. We have selected the geometrical parameters to maximize the short circuit current delivered by the a-Si cell at a given selected wavelength. The design has been customized to gas measurements application, where the index of refraction is slightly above 1 around 10[Formula: see text]. Our analysis reveals ultra-high sensitivity of [Formula: see text] (mA/W)/RIU, and a figure of merit FOM= 107 RIU[Formula: see text], when the bow-tie is made of SiO[Formula: see text]. A performance rally competitive with those previously reported in literature, with the additional advantage of circunventing both moving parts and spectral interrogation elements.