Perimeter and carvacrol-loading regulate angiogenesis and biofilm growth in 3D printed PLA scaffolds

Carvacrol is a natural low-cost compound derived from oregano which presents anti-bacterial properties against both Gram-positive and Gram-negative bacteria. In this work, carvacrol-loaded PLA scaffolds were fabricated by 3D printing as platforms to support bone tissue regeneration while preventing biofilm development. Scaffolds were printed with or without a perimeter (lateral wall) mimicking the cortical structure of bone tissue to further evaluate if the lateral interconnectivity could affect the biological or antimicrobial properties of the scaffolds. Carvacrol incorporation was performed by loading either the PLA filament prior to 3D printing or the already printed PLA scaffold. The loading method determined carvacrol localization in the scaffolds and its release profile. Biphasic profiles were recorded in all cases, but scaffolds loaded post-printed released carvacrol much faster, with 50-80% released in the first day, compared to those containing carvacrol in PLA filament before printing which sustained the release for several weeks. The presence or absence of the perimeter did not affect the release rate, but total amount released. Tissue integration and vascularization of carvacrol-loaded scaffolds were evaluated in a chorioallantoic membrane model (CAM) using a novel quantitative micro-computed tomography (micro-CT) analysis approach. The obtained results confirmed the CAM tissue ingrowth and new vessel formation within the porous structure of the scaffolds after 7 days of incubation, without leading to hemorrhagic or cytotoxic effects. The absence of lateral wall facilitated lateral integration of the scaffolds in the host tissue, although increased the anisotropy of the mechanical properties. Scaffolds loaded with carvacrol post-printing showed antibiofilm activity against Staphylococcus aureus and Pseudomonas aeruginosa as observed in a decrease in CFU counting after biofilm detachment, changes in metabolic heat measured by calorimetry, and increased contact killing efficiency. In summary, this work demonstrated the feasibility of tuning carvacrol release rate and the amount released from PLA scaffolds to achieve antibiofilm protection without altering angiogenesis, which was mostly dependent on the perimeter density of the scaffolds.