Related Experiment Video
Updated: Aug 22, 2025
Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Reduction Capacity and Factors Affecting Slip Reduction Using Cortical Bone Trajectory Technique in Transforaminal
Keitaro Matsukawa1, Kanehiro Fujiyoshi1, Yoshihide Yanai1
1Department of Orthopaedic Surgery, National Hospital Organization, Murayama Medical Center, Tokyo, Japan.
Introduction:
Vertebral slip reduction has been recommended in arthrodesis for lumbar degenerative spondylolisthesis (LDS) to achieve balanced spinal alignment and bone fusion. However, what determines the degree of slip reduction using cortical bone trajectory technique for lumbar pedicle screw insertion is yet to be determined. Thus, in this study, we aim to investigate the slip reduction capacity using cortical bone trajectory (CBT) technique and to identify factors affecting the slip reduction rate.
Methods:
This is a retrospective radiological evaluation of prospectively collected patients. In total, 49 consecutive patients who underwent single-level transforaminal lumbar interbody fusion for LDS using the CBT technique were included (mean follow-up: 28.9 months). Firstly, radiological parameters of fused segment including the percentage of anterior vertebral slip (%slip), lordotic angle, and disk height were measured. Then, patient and procedure-related parameters were examined to determine factors related to the slip reduction rate using multiple regression analysis.
Results:
The %slip was reduced from 15.0±4.8 to 1.6±2.3% immediately after surgery and 2.2±2.9% at the last follow-up (p<0.01), with a slip reduction rate of 87.5±15.7% and correction loss of 0.6±2.1%. As per multivariate regression analysis, it was found that preoperative %slip (standardized regression coefficient [β]=-0.55, p=0.003) and the depth of screw insertion in the caudal vertebra (β=0.38, p=0.03) were significant independent factors affecting slip reduction rate (adjusted R2=0.29, p=0.008).
Conclusions:
To the best of our knowledge, this study is the first to investigate the capacity for and factors affecting slip reduction using the CBT technique for LDS. The CBT technique may be a useful option for achieving slip reduction, and the depth of screw insertion in the caudal vertebra was identified as a significant technical factor to obtain a more significant reduction of slipped vertebra.
