The difference between drainage channels and sewers in rural areas: from sewage quality to bacterial characteristics

Yun Han1, Wenkai Li1, Tianlong Zheng2

  • 1SCEGC No. 12 Construction Engineering Group Co., Ltd., Ankang National High-tech Industries Development Zone, Ankang, Shaanxi 725000, China

Related Concept Videos

Design Example: Design of an Irrigation Channel01:27

Design Example: Design of an Irrigation Channel

Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
181
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
161
Gradually Varying Flow01:29

Gradually Varying Flow

Gradually varying flow (GVF) in open channels describes situations where water depth changes slowly along the channel due to factors like non-uniform bed slope, channel shape variations, or obstructions. This flow type occurs when the depth adjusts gradually to balance gravitational forces, shear forces, and energy requirements, resulting in a low rate of depth change.Characteristics of Gradually Varying FlowGVF is commonly observed in natural streams, rivers, and canals, where flow depth...
102
Weir: Problem Solving01:26

Weir: Problem Solving

Water flow in open channels is often measured using hydraulic structures such as weirs, which allow precise calculation of discharge. In a rectangular channel, flow rates are measured using three types of weirs: rectangular sharp-crested, triangular sharp-crested, and broad-crested. The weir head is set at a fixed height above the channel bottom, simplifying calculations and enabling the relationship between depth and flow rate to be analyzed.For the rectangular sharp-crested weir, the flow...
93
Urine Studies II: Urine Culture and Sensitivity Test01:26

Urine Studies II: Urine Culture and Sensitivity Test

A urine culture and sensitivity test is a diagnostic procedure used to identify urinary tract bacterial infections and determine the most effective antibiotics for treatment. This test is generally preferred when a patient shows manifestations of a urinary tract infection, such as frequent or painful urination, cloudy or foul-smelling urine, or lower abdominal pain.Purpose of the TestThe primary goals of a urine culture and sensitivity test are to:Determine the specific bacteria causing the...
87
Surface Membrane Barriers01:18

Surface Membrane Barriers

The skin and mucous membranes serve as the primary line of defense against pathogens by providing both physical and chemical protection. These barriers are essential in preventing the entry and establishment of microbes, thereby maintaining the integrity of the host.
The outer layer of the skin, the epidermis, is a robust barrier comprising layers of closely packed keratinized cells. This dense arrangement prevents microbes from penetrating the body. The periodic shedding of epidermal cells...
1.3K