Scaphotrapeziotrapezoid joint loading during key pinch grip before and after trapeziometacarpal arthroplasty: a...

In a previous cadaver study, we directly measured the load acting on the trapeziometacarpal joint for increasingly greater key pinch forces. We noted that the joint load ranges from 2 kg to 4 kg during progressively greater key pinch from 0.5 kg to 1.5 kg. Using the same experimental approach, the aim of the current study was to measure and compare the load acting on the scaphotrapeziotrapezoid joint for the same levels of isometric key pinch force, and how it changes after trapeziometacarpal arthroplasty. We performed a cadaver study using 7 fresh-frozen, unembalmed adult forearms and hands (2 right and 5 left). Thumb pinch was simulated by loading the main actuator tendons involved in the key pinch grip (i.e., adductor pollicis, flexor pollicis longus, extensor pollicis longus, extensor pollicis brevis and abductor pollicis longus tendons). Measurements were made inside the joint using a force-sensing resistor sensor (Tekscan® FlexiForce™ force sensor). Before the trapeziometacarpal joint surgery, median load values recorded in the scaphotrapeziotrapezoid joint were 1.2 kg (IQR, 1.0-1.4), 1.6 kg (IQR, 1.6-2.5) and 2.4 kg (IQR, 2.3-3.4) during 0.5 kg, 1 kg and 1.5 kg key pinch, respectively. After the trapeziometacarpal arthroplasty, median joint contact forces did not change significantly relative to the original configuration. Our findings indicate that the loads measured in the scaphotrapeziotrapezoid joint during a simple key pinch are in fact lower than those measured inside the trapeziometacarpal joint. After trapeziometacarpal arthroplasty, the values are similar with no increase in load, suggesting that clinically asymptomatic scaphotrapeziotrapezoid radiographic involvement may not be a contraindication to arthroplasty.