Establishment of a finite element model of supination-external rotation ankle joint injury and its mechanical...

By establishing a three-dimensional finite element model of ankle injury arising from supination and external rotation, the stress characteristics of the posterior malleolar surface can be obtained, and analysis of the corresponding stress on the lateral ankle can be conducted. Thin-layer computed tomography images of normal ankle joint in the supination and external rotation nonweight-bearing states was selected, to construct a three-dimensional data model of each ankle joint. A load was applied to examine different ankle joint stress values and pressure distributions on the surface of the posterior ankle joint. A 600 N vertical compressive and 10 Nm internal rotation load was applied in Stage III (removing the anterior tibiofibular ligament and the posterior tibiofibular ligament) of SER (supination-external rotation). When the lateral malleolar was intact, the maximum stress (132.7 MPa) was located at the point of attachment of the posterior tibiofibular ligament to the fibula, and the maximum pressure of the posterior malleolar surface was lower than 4.505 MPa. When a lateral malleolar fracture was present, the maximum stress (82.72 MPa) was located on the fibular fracture surface, and the maximum pressure of the posterior malleolar surface was 8.022 MPa. This study shows that reconstruction of the lateral malleolus in supination-external rotation ankle injuries significantly affects the stress distribution at the posterior malleolar joint surface. Through this reconstruction, the pressure distribution of the posterior malleolar joint surface can be significantly reduced.