Related Experiment Video
Updated: Aug 19, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Experimental investigation of dynamic mechanical characteristics of inhomogeneous composite coal-sandstone
Yunchen Suo1,2, Ning Luo1,3,2, Yabo Chai1,2
1State Key Laboratory for Geo-mechanics and Deep Underground Engineering, China University of Mining and Technology, Xuzhou 221116, China.
Abstract:
In deep resource exploitation, the coal seam and the strata are jointly loaded, forming a systematic combined structure that can have a significant effect on coalbed methane (CBM) development. Therefore, to understand the deformation and damage characteristics due to blasting load of the complex and real ground conditions, the 50 mm split Hopkinson pressure bar (SHPB) was used to study the dynamic performance and energy changes of coal-sandstone combination and sandstone-coal combination as inhomogeneous materials. In addition, high-speed photographic equipment was employed to determine the damage failure mechanisms. The results showed that the dynamic compressive strength and failure strains of two combinations showed polynomial relationships with increasing strain rates. The strain rate effects and likenesses of the two combinations' energy and energy rates were substantial. Furthermore, for the coal-sandstone combination, the initial damage fractures occurred at the end face near the bar, and at the interface for the sandstone-coal combination. Eventually, the improved constitutive model based on the ZWT was significantly consistent with the two combinations. The related theory can perform an effective and practical role in the mining of coal rocks under complex ground conditions for CBM development.
Related Concept Videos
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by...
Permeability of Concrete
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
Measurement of Air Content in Concrete
The pressure method,...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Porosity in Cement Paste
The balance of water to cement in the mix is...

