Coronal discoloration induced by calcium silicate-based cements used in full pulpotomy in mature permanent molars: a...

This study aimed to randomly compare in vivo coronal discoloration at 6 and 12 months after full pulpotomy in mature permanent molars using MTA, Biodentine, and TotalFill and to investigate the effect of variables such as remaining buccal wall thickness and time to achieve hemostasis.

One hundred eight teeth that met the inclusion criteria received full pulpotomy and were randomly divided into 3 groups via a block randomization technique according to the calcium silicate cement (CSC): ProRoot WMTA, TotalFill, or Biodentine. Assessment of tooth color was carried out using a spectrophotometric device (VITA Easyshade Compact) after composite placement (T0), at 6- and 12-month follow-up. Buccal wall thickness and time to hemostasis were recorded. The primary outcome measure (color change ΔE) was calculated, and the results were analyzed by three-way ANOVA and crosstabulations in relation to material type and effect of variables.

Four cases were excluded after pulpotomy failure; 81 teeth were evaluated at 6 months and 95 teeth at 12 months. All CSCs caused tooth discoloration (defined as ΔE > 3.7); MTA significantly caused the highest color change at 6- and 12-month follow-up (76% (19/25) and 87.5% (28/32), respectively) compared to Biodentine (41% (9/22), 48% (13/27)) and TotalFill (44% (15/34), 53% (19/53)) (p = 0.022, p = 0.002), while no significant difference was found between the Biodentine and TotalFill groups (p = 0.813, p = 0.8). Buccal wall thickness (above or below 2.7 mm) had a significant effect on the degree of discoloration (p = 0.004).

The 3 CSCs caused tooth discoloration based on the threshold of ΔE > 3; the remaining buccal wall thickness was a significant factor. The use of Biodentine and TotalFill instead of MTA is encouraged to minimize discoloration.

While experimental studies report coronal discoloration after CSCs use, clinical data is lacking. This study assessed discoloration using a spectrophotometric device. The use of materials with lower discoloration potential in pulpotomy is encouraged.

The study was registered with clinical trial registration number: NCT04346849 on 14.4.2020.